DIY Electric Car Forums banner

siemens 1fv5139

4K views 8 replies 3 participants last post by  bigmouse 
#1 · (Edited)
#2 ·
I've been keeping my eye on this for a while now. It was $1500 when I started watching it. With a 650vdc bus, my conversion is one of the few that could actually fully utilize it since that's my bus voltage already.

4000rpm redline is a bit low. I would hesitate to push it beyond that because it's probably limited mechanically by the magnet retention. For $700, it would be an awesome deal if I had an immediate use for it!

If I didn't already have a motor arrangement sorted out, I'd consider it.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top