[NintendoKD]

Looking into do-ing an ev build on my spyder. A little backstory first. I got the spyder at a salvage car auction I fixed the damage, and had a running car. My friend was leaving to go home to florida and needed the engine but didn't have the 2k to get a new 1zzfe plus the transmission. I, being the good friend that I am, gave mine to him NQA. I now have a very pretty lawn ornament with brand new tires and suspension. I want to do this conversion with an Onan genset, a 3k, and a hiper drive ac-50. For those not in the know, the ac-50 is a 3-phase a/c motor.

[madderscience]

If only I had friends I could borrow parts off their cars and take them to florida NQA

Sounds like a fun project. Suggest building a good EV first, then figuring out the genset part. Be aware some chargers have problems with generator output current, and if you want enough generator power to maintain freeway speed you need about 10kw from the generator, not 3kw. 3kw would extend your range and allow for recharging while parked though, but if part of your goal is a cleaner vehicle, then running a portable generator with its very dirty single cylinder gas engine much at all would quickly negate any gains.

The AC50 setup is a great setup for smaller cars, but is not a high performance system.

If you are looking for technical feedback, it would be useful for us to know your expectations and design plans. See the sticky for new posters.

cheers.

[NintendoKD]

Originally Posted by madderscience

If only I had friends I could borrow parts off their cars and take them to florida NQA

Sounds like a fun project. Suggest building a good EV first, then figuring out the genset part. Be aware some chargers have problems with generator output current, and if you want enough generator power to maintain freeway speed you need about 10kw from the generator, not 3kw. 3kw would extend your range and allow for recharging while parked though, but if part of your goal is a cleaner vehicle, then running a portable generator with its very dirty single cylinder gas engine much at all would quickly negate any gains.

The AC50 setup is a great setup for smaller cars, but is not a high performance system.

If you are looking for technical feedback, it would be useful for us to know your expectations and design plans. See the sticky for new posters.

cheers.

I am going to replace the diode pack and get some more juice from the genset. The idea is to add some range and give the ability to charge while stopped. There are ways to have a perfectly clean generator exhaust output, and it by far emits less than a larger, higher output engine on a bad day. I will have this managed, and this will allow for me to use a heater in the colder months. I will have nowhere near 10KW, however, it will be enough to get around. I don't want a high performance system....... yet. I just want to try my hand at this, and have a plug in car. Too bad you don't have any good friends, you just haven't met me yet.

thanks,

Nintendo

[NintendoKD]

I was a proud member of the www.battleofthebuilds.com Kai Hei Tai team, and am versed in fabrication, and mechanics. I wish I had the machining equipment to do some of the things I want to do.
Not really sure on the mileage, I think I'll take it a step at a time. I am working with a mid-engi...... errr mid-motor mounted vehicle.
As for performance, I don't want a rocket ship....... yet. I just need something to get the smog doctor off my back.
Money, hmmmmmm. well, I guess you could say I don't have much capital, but I am resourceful, and that goes a long way.
onan generator, 3-phase a/c motor, vw transmission, "I have a few of these just sitting around" I don't know about coupling with a manual or automatic, or if that makes a difference. I am looking to use as few of the electric accesories as possible, to make better use of the mileage as possible.
I am interested in the concept of regenerative acceleration and lenz's law, as well as using an lc circcuit for high frequenct high voltage to achieve better efficiency.

[NintendoKD]

a useful link for the mr2 spyder.
http://spyderchat.com/specifications.htm

[NintendoKD]

ac propulsion t-zero.....DROOL..... ahem, so I just need to get going cheap is probably better, where can I source an a/c 3-phase motor? I have access to DRMO, which is a military salvage operation on base here.