DIY Electric Car Forums banner

can bus

  1. All EV Conversions and Builds
    Hi everyone, I'm working con converting Peugeot RCZ to use Tesla drivetrain. I need donor car's power steering and brake system remain. After research and tested, it required CAN bus signal (may be RPM, VSS) from engine to wakeup electric pump for steering hydraulic line. Which I don't have...
  2. Controllers
    Hi, I want to operate Curtis DC Motor Controller's throttle via CAN-BUS (Curtis already support CAN input for throttling). In this regarding, I would like your confirmation that can we directly control DC Motor Controller's throttle from vehicle's OBD2 CAN-BUS pins (check attached image)...
  3. Technical Discussion
    I am converting a BMW Mini Clubman to electric drive with an AC induction motor and Curtis 1238-6501 controller. The donor car has electric power steering / ABS etc which need road speed and engine speed on CAN BUS to opperate. As the engine is removed, I have lost the signal and the power...
  4. Parts Vendors
    Keybox is a smart relay module for electric loads that make it possible to utilize keypads where there are no PLC systems onboard. Thanks to its CAN bus interface and high power outputs, Keybox can also be used in “slave” mode with complex systems. 3 Models Available - KB-12V-05A 13 relays (12...
  5. Batteries and Charging
    ---SOLVED--- Thanks for all the help Hi everyone, I have an Orion BMS revision E and I'm having trouble connecting the BMS over CAN bus. I have the CANADAPTER that's supplied with the BMS from Ewert Energy. I've contacted Ewert Energy about my problem, but I figured I'd post to the forums and...
  6. Batteries and Charging
    Hi all, I encounteredon a small problem at my electric conversion. From the supplier I get the charger with activated CAN BUS. But the charger was delivered without CAN BUS unit. Supplier promised deliver new CAN bus unit, but the time it's over 3 weeks. I need urgently charge the battery, it's...
  7. Batteries and Charging
    Hello all, About 3 years ago (ish. It's been a while) my father and I began converting a '95 Probe GT to electric. It went through some necessary changes (read: newer controller when we blew up the first one) and we've now had it to the point where it drives for most of the summer. It's got...
Top