DIY Electric Car Forums banner
dc to ac inverter

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. Controllers
    Hello everyone, I am building an electric shuttle, I am using a Nissan note e-power motor. The controller I selected is the P&S DIY 200KW. I have received all the files from Paul but there is only BOM of the resolver to encoder inside that and not the schematic/PCB/Gerber file Can someone help...
  2. Electric Motors
    Hello everyone, my first query here. Hope to get maximum response. I am designing a shuttle bus intended to carry 13 passengers, the load calculations come up to be 3000kg. I am planning to take every part from junk and design+manufacture the whole vehicle. Initially, I am getting a Nissan...
  3. All EV Conversions and Builds
    I'm pretty new to this community and I'm just getting into my first EV conversion. However, I'm very confused about where to go with the motor and inverter. First, I would like to say I'm just a college student and I'm on a very tight budget so most of this surrounds the cost of these...
  4. Technical Discussion
    I have a DIY EV conversion (9" ADC motor and Zeva 1000 amp motor controller) using 36 leaf cells (18S2P) battery pack to provide ~148V at max charge. Since i don't drive it in the winter (think safety and rust) i have a readily available electrical storage unit just sitting in my garage -...
1-4 of 4 Results