DIY Electric Car Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. New Member Introductions
    I'm just getting started on planning my ev conversion. I would like to replace the rear axle of an F-150 with an electric driven axle(pictured). As well as replacing the front differential with a electric driven differential gearbox. I have very little experience with working on vehicles but...
  2. Classifieds
    If you've replaced your original Tesla open diff with the Quaife limited slip unit, or if you have a DU with a busted /cracked case, I'd be happy to recycle the old unit from you to run some experiments with. Please PM me if you have one sitting around the shop. thanks
  3. All EV Conversions and Builds
    I am designing a low speed(6mph) electric vehicle that will be used to transport loadings of about 400lb and will have total weight(loaded) of 1400lb. I will be using an electric motor with a 19 tooth spline from a golf cart and calculated I need a gear ratio of 25:1. However no rearend...
  4. Technical Discussion
    I need an elcar differential. I can only get info that this was a direct drive. What differential type did zagato zeles use. Is there any bearing rebuild kits for these?
1-4 of 4 Results
Top