Joined
·
1,024 Posts
Current is simply set by a PWM signal
4 amps... It's not officially supported, if you did it anyway your charger would likely not handshake.
If you map your chargers power in behavior you might find its ramps slowly over 30 seconds to a minute, it would be much more complex but you could reset to 0 amps every 20 seconds or something so your charger doesn't draw over 4 amps
Ah well
Good Luck
4 amps... It's not officially supported, if you did it anyway your charger would likely not handshake.
If you map your chargers power in behavior you might find its ramps slowly over 30 seconds to a minute, it would be much more complex but you could reset to 0 amps every 20 seconds or something so your charger doesn't draw over 4 amps
Ah well
Good Luck
