DIY Electric Car Forums banner
Cancel

98 Saturn SC2 with Warp 9 and adaptor plate

5931 Views 11 Replies 3 Participants Last post by  BWH, 
P
2
I have a 98 Saturn SC2 with a Warp9 motor and adapter plate installed. I'm asking 2500 but will consider less. Please contact me if you would like to see more pictures. I also created two metal battery brackets made from angle iron. I started working on this a few years ago, but just don't have any fee time.

I'm located in the Scranton PA area.

Patrick

Attachments

See less See more
Reply
Save
Like
1 - 2 of 12 Posts
B
Sorry for jumping in, but I have a '97 SL with a WarP9 and an EA adapter myself. :)

I just wanted to share another driveshaft support option:


I had a racing shop down the street make this and the motor mount for me. Since these cars are identical the template they have should fit yours as well.
See less See more
Reply
Save
Like
B
I wish I was a welder. :rolleyes: The cost for the metal was next to nothing, but I ended up paying several hundred for the design/welding hourly rate.

That was for a couple of mounts as well. Since it's only one piece and they've already made it before I'm sure it would be much cheaper.

Never hurts to ask.

http://www.jandeperformance.com/
Reply
Save
Like
1 - 2 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
DIY Electric Car Forums
A forum community dedicated to DIY electric car owners and enthusiasts. Come join the discussion about electric vehicle conversions, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
All EV Conversions and Builds Batteries and Charging Technical Discussion New Member Introductions eBay EV-Related Auctions
Top