DIY Electric Car Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
thinking i might try to 3d print a motor couple for a nissan leaf. would this be smart if i beefed it up? wanna run some simulations but ive never simulated anything before just modeled lol.
of course it would be able to work at walking speeds but idk maybe i could design one that by shear mass could withstand a leaf motors torque which compared to a tesla isnt a lot. but still a lot for plastic. so im not sure. i think ill give it a try though. whats the worst that can happen? plastic exploding?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top