DIY Electric Car Forums banner
1 - 3 of 5 Posts

· Registered
157 Posts
Discussion Starter · #5 ·
Already plan to fuse the positive leg on each battery box, plus a service disconnect per box, contactor on positive and negative legs for redundancy and an inertia switch somewhere in there. I have experience with pcb manufacturing so I was thinking of building a board internal to the battery box with connectors to each battery module for thermistors and taps, and integrating pico fuses into that board. Just wasn't sure if it's necessary.
1 - 3 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.