DIY Electric Car Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
I have the opportunity to buy an ADC 203-06-4001 motor at a good price but my application would have a pulley for a chain or belt drive to a solid axle. Has anyone put the pulley directly on the motor shaft and, if so, have you had any problems with the shaft bearings?



The project is to convert my old Zink 19 F440 to electric and move from F-mod to A-mod class for autocross. Weight with the new drive and driver should be around 60 to 700 lbs. Battery pack is planned for 120 volts, 40 AH LTO modules.
 
1 - 1 of 1 Posts
Top