DIY Electric Car Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
We used to install plug-in upgrades to Prii, and we now have many broken Elcon chargers for repair that we do not need. Once you get them to work, they can be reprogrammed to fit your charge curve (see Elcon's website). We're looking to sell them for $20/charger plus the cost of shipping. We have:

7x 240-5
3x 216-10
4x 288-7.5
3x 288-7
1x 288-8

Number(we have)x Voltage(preset but can be changed)-Amperage
Ex. We have 7 chargers with a nominal output of 240V at 5A.

All of these can be re-programmed, as they were all purchased for a 274V system, with a charge curve for Li-ion cells. We have the associated DIN plug connector to go with them as well.
 

·
Registered
Joined
·
1,478 Posts
pm sent

Wow i didn't know that was a thing:
The message you have entered is too short. Please lengthen your message to at least 10 characters.
 

·
Registered
Joined
·
83 Posts
Yes, i am interested as well. I believe Kennybobby and I repaired some of these for you before.
Hi Pdove - did you get any of these, can one be reprogrammed to around 128v?

Although at only 10A id be waiting quite a while to charge.

Dave
 

·
Registered
Joined
·
374 Posts
I never heard from anyone on these chargers.

I may have one I can sell you but it may take a week for me to get to it.
 

·
Registered
Joined
·
83 Posts
I never heard from anyone on these chargers.

I may have one I can sell you but it may take a week for me to get to it.
As you know from the other thread - hoping to have 36s of LifePo4 batteries - Somewhere around the 130v charging rate is below the optimum but should give me around 90% (I hope if they are holding charge, still to test...)

Let me know the specs and cost, that would be grand - cheers

Dave
 
1 - 6 of 6 Posts
Top