DIY Electric Car Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter · #1 · (Edited)
Brusa NLG503 1.6kW charger for sale. The charger has been used for around 3 years but it still in excellent working condition (I am upgrading to a 3kW charger).

Charger features include:
-Up to 1.6kW operation
-Programmable charging modes for intelligent charging
-CANBUS control for digital BMS interface (not required)
-Air cooled, side fan configuration
-Wide output voltage range (200v-520vDC)
-Compatible with 120vAC or 240vAC charging
-High typical output efficiency (93%)
-12v output for powering electronics while charging

The following items are included:

Brusa NLG503 (1.6kW Charger)
Software utility disk
Both DC and AC high power cables + mating connectors ($365 new)
Low voltage I/O connector + pre-wired communication lines (CAN & Serial)


**SOLD**
 

Attachments

·
Registered
Joined
·
26 Posts
Discussion Starter · #4 · (Edited)
Hi Guys,

I have another one of these 1.6 kW Brusa chargers. Same condition as the other charger (used but in good working order).

NLG503 charger, see first post in this thread for details on the charger itself.

I will include all the cables except the AC inlet side. This can be purchased separately from Brusa.

Looking to get $700 for the charger + the DC power cable and the I/O Brusa cable (serial, power, inputs, etc).

Offers welcome, let me know if there are any questions

**SOLD**
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top