DIY Electric Car Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
87 Posts
Discussion Starter · #1 · (Edited)
Please can anyone help me to set up my device for controlling the Elcon TC charger -

I have all of the information I need and I have a great USB CAN device with good easy to use software but I am useless when it comes to grasping how to wright the simple code to set it up

I only want and need to get the charger to go - and set max voltage and amps

I dont mind to pay for a result if that is required -

this is the link to the Charger command requirements

https://1drv.ms/f/s!AmbWDB9AS-tJhb0vqhxQ9NrgCa7Rvw

I also bought an Arduino uno and a can bus shield but I could not even get the windows 10 drivers to see into it - I suppose there is a way but if you are like me and not in the know its impossible....
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top