DIY Electric Car Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
260 Posts
Discussion Starter #1
I just got my Leaf pack....finally.....and I would like to check the voltage on it. I put the service plug on and put my meter on the connector at the end but got nothing. I know that it would not charge until the precharge is done so, is there a way to check this without opening it up or connecting the whole wiring loom, motor and other gauges etc?
 

·
Registered
Joined
·
247 Posts
You can control the main relay inside the pack from the round plug on the front to get the voltage output on the main terminals. Also you need to install the breaker/safety plug on top of the pack.
 
1 - 2 of 2 Posts
Top