DIY Electric Car Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
337 Posts
Discussion Starter #1
Wiring up the pack. After doing 70% of it, I read on evworks that it's a good idea to clean the terminals with a wire brush to remove aluminium oxide. So disconnected all the cells and BMS cabling. A whole day "wasted" - except that it will hopefully perform better with the lower resistance. I was surprised at the change in colour/albedo on some of the terminals, I'd never noticed they were oxidised.
 
1 - 3 of 3 Posts
Top