DIY Electric Car Forums banner
1 - 1 of 2 Posts

· Registered
27 Posts
Discussion Starter · #1 ·
I want to operate Curtis DC Motor Controller's throttle via CAN-BUS (Curtis already support CAN input for throttling). In this regarding, I would like your confirmation that can we directly control DC Motor Controller's throttle from vehicle's OBD2 CAN-BUS pins (check attached image)?

TARGET: My ultimate target is to run a DC Brushless/Brushed Motor on 100% same RPM as of Vehicle's Engine RPM (on all different loads)



1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.