DIY Electric Car Forums banner
Cancel

Convert DCP Raptor controller to use external 0-5v hall throttle?

529 Views 1 Reply 1 Participant Last post by  hummbug, 
H
I have a setup using the DCP 600 Raptor. It uses an external inductor as a throttle controller. I am certain of this as I drive it all the time (I know there were a couple variants of these).

There are several good external hall-based throttles on the market now and I'd like to use one and get rid of my janky home-made type coil and spring setup. Anyone know how to modify these controllers to use a 0-5v signal instead of the inductor?

Thanks in Advance!!
Save Share
Reply Quote
1 - 2 of 2 Posts
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
DIY Electric Car Forums
A forum community dedicated to DIY electric car owners and enthusiasts. Come join the discussion about electric vehicle conversions, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
All EV Conversions and Builds Batteries and Charging EVDL List Technical Discussion New Member Introductions
Top