DIY Electric Car Forums banner

Curtis 1238-7501 not showing charge

Jump to Latest Follow
1 - 2 of 2 Posts
D

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
My wheego has no state of charge it's in limp mode only two codes 44 and 51 the 51 is a oem code but it's probably saying it's in limp I have 101.8 volts to the terminal but nothing on the gauge
 
D

·
Registered
Joined
·
9 Posts
Discussion Starter · #2 ·
I figured it out my fuel gauge driver needed to be reset after I was at full charge it was disconnected when the battery pack was off so it reset wronged the other codes were related to a brake transducer that was bad
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
About this Discussion
1 Reply
1 Participant
Last post:
Dbdeakin
DIY Electric Car Forums
A forum community dedicated to DIY electric car owners and enthusiasts. Come join the discussion about electric vehicle conversions, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
All EV Conversions and Builds Batteries and Charging Technical Discussion eBay EV-Related Auctions New Member Introductions
Recommended Communities
Community avatar for VWVortex Volkswagen Forum
VWVortex Volkswagen Forum
1M+ members
Community avatar for Raptor Forum
Raptor Forum
73K+ members
Community avatar for Seat Arona UK Forums
Seat Arona UK Forums
2K+ members
Top