DIY Electric Car Forums banner

Curtis 1238 extract data in Arduino

1022 Views 3 Replies 4 Participants Last post by  hummbug
Hello, good evening my brothers

I have a Curtis 1238, which I want to extract data through Can Bus with the MCP2515 adapter and an Arduino, but I can't get CAN BUS communication, I've browsed the internet, downloaded and tried a thousand codes but I can't get them, can someone help me?

Thank you brothers!
1 - 1 of 4 Posts
If you have a scope look at the CAN lines and see if you see signal. High and Low. Some firmwares of the Curtis don't do CAN as I understand it.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.