DIY Electric Car Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
369 Posts
Discussion Starter #1
I want to wire a Curtis unigage 933/1c001224j003c and I also have a 902rb1224bnaac. The 933 has a wire harness with six wires and two adjustments, reset and discharge and the 902 has male qd's labeled 1-12, 2-24, 3-B-, and 4-KS. I got them from forklifts. Can't seem to find any manuals on them...

The 902 seems easy enough to figure out, but I dont want to risk blowing it up just yet.

Thanks,

Brian, www.evalbum.com/1752
 

·
Registered
Joined
·
369 Posts
Discussion Starter #2
OK, KS is for Key Switch, ran it at 24V, works great! Might use it across 24V of my 144V to give me a good measure. My Pak-Traker does not work. Keeps resetting, and now loop C is on the fritz.
So now to figure out the unigage...
 
1 - 2 of 2 Posts
Top