DIY Electric Car Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello,

I have BMW i3, the charger included is Delphi 10A which charge a bit too slow,
is it possible just to change the resistor between (CP and GND) 1.5kΩ to 680Ω and get more power ?
I have a good connection to 240V, cables can handle much more than 10A but, will changing just resistor would allow the car to take more than 10A ?

thank you!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top