DIY Electric Car Forums banner
1 - 3 of 4 Posts

12 Posts
Discussion Starter · #1 ·
Hi all,
I am working working on a 600V/600A sensorless inverter than can work on ACIM, PMSM and BLDC using FOC sensorless with a firmware called InstaSPIN (Texas Instriuments)

I like InstaSPIN because we have been testing some other FOC algorithms*and InstaSPIN give better results, Especially with very high currents close to motor saturation. That's means we get more torque for the same motor with InstaSPIN.

About the project: For the power stage, it is based on Infineon FF600R06ME3 modules with SCALE2 drivers. About control I am using a development board from TI: LAUNCHXL-F280049C, It can use any InstaSPIN Launchpad of TI but this board runs a new version of InstaSPIN, This is the version than TI is developing*and supporting right now.

I already have almost all the materials, Infineon IGBTs, SCALE2 drives, the PCB...., so it is time to start mounting, I hope that soon I will have real photos of the inverter

1 - 3 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.