DIY Electric Car Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
291 Posts
Discussion Starter · #1 ·
I am not fond of the Leaf instrument cluster so I was wondering how difficult it would be to take the speed input and convert it to run my cable driven mechanical speedo. The question holds true for other display items such as battery monitor. Any thoughts?


Here is the dash look I wish to keep (if possible). There is lots of space to put small displays if needed.
 

Attachments

·
Registered
Joined
·
291 Posts
Discussion Starter · #3 ·
If you can get it apart (some are sealed like a soup can) there are mounting points that can be converted to hold different drive schemes, like using the motors from current gauges. Could even be companies doing retro conversions for them late model swaps where they are basically new frames and guts with a vintage body.

I was thinking of putting a small motor onto the existing speedo to be driven by the signal to the leaf cluster but I don't know enough about the system to know what needs to be done.
 

·
Registered
Joined
·
291 Posts
Discussion Starter · #10 ·
The English page is missing the description, but Google can translate the Dutch page.

Based on the instructions, this appears to use a set of magnets strapped around the propeller shaft (a.k.a driveshaft... you would have to use the inner CV joint on one axle shaft), and a magnetic pickup ("pulse generator") to produce the electronic pulses needed to control the motor which rotates the speedo cable. The translated Dutch description and photo confirm that.

Not the most elegant thing but quite usable and a good idea. $300, hmmmm
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top