DIY Electric Car Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #3 ·
i am using a emus bms and curtis 1239e (from hpevs) i did explore can connection between the two but it did not seem particularly straitforward and in the end i've decided initially to keep them separate - what did u want to do exactly ???
I wondered if it would control the output of the batteries and shutdown or cut back out put if any battery discharge issues were sensed.

Right now I am having difficutly setting up the EMUS BMS with the ELCON charger. I cannot seem to get past the configuration page and get the charger to start.
Any ideas?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top