DIY Electric Car Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
45 Posts
As Adrian mentioned...racing websites are a good place to go for brake upgrade info...especially Honda Civics. In my case I found a site that gave me the complete blueprint to upgrade my brakes. I did retain my 8" booster however and my brakes are rock solid. Read my album entry for more info and the link.

When it came to the vacuum pump, I followed Ken Norwick's advice here http://www.docdockdocuments.com/conversion/Conversion20.htm
and the next page http://www.docdockdocuments.com/conversion/Conversion23.htm

I went to my local "PICK YOUR PART" wrecking yard in Northern California http://www.pickapart.com/ . They have occasional 50% weekends and in fact...everything I got for my civic, I waited for these. Anyway, I hunted down 4 of these pumps with my buddy Karl http://www.austinev.org/evalbum/1259
and I swear...we got them for like 16 bucks a peice I remember. This pump is fantastic! We hooked one up to 12 volts, plugged the suction tube and immediately the pump quit. Unplug the tube and it turns right back on all by itself because it has a built in vacuum switch. With my home made PVC vaccum reservoir..it works great! My small reservoir is only enough for two brake applications before it comes on but it takes like 15 seconds for the pump to take it down and shut off again. I need a bigger reservoir. Of the four we got..only 3 actually worked though. Here is another link that shows you what cars actually had it and how to install it http://www.gmcmotorhome.com/tech/vacuum_pump/index.html It is aimed at RVs but it suits our purposes as well. All the vehicles I found it on had it located inside the driver's side front wheel well. Its kinds of hidden so another clue to finding the right car is to look for a vacuum hose coming from this location and going to the booster....a sure sign one is down there. Make sure to get that nice weatherproof electrical connector with wires and leave a length of vacuum hose attached to the the pump so you can stick the check valve in it...extra value...heh heh. :)
Another bonus is that this unit is compact and light...look where I mounted mine!:D I also have a length of left over vacuum hose attached to the exhaust side and leading down to the ground to muffle it somewhat and with this hose attached..its really not that noisy at all. Some more tips that may save you a return trip if you go hunting for it. 1. bring "Torx" bits to take off the three mounting bolts..like these http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=94188 I dont remember what size specifically though. 2. Bring canned air...like the type you use to blow dust out of your keyboard. The pump sits below where the battery is and the Torx bolts are right below the battery so there is alot of corrosion. I couldn't even see the bolts until I blew out the dust and rust flakes. 3. After blowing out the dust/rust particles to expose the 3 bolt heads...soak them for a bit with a good penetrating oil because THEY WILL STRIP if you don't most likely. I had to abandon 2 clean looking pumps when I did this and move on to fresh ones when I later came back with the canned air and oil. Hope this helps somebody!
 

Attachments

· Registered
Joined
·
45 Posts
How about this?
Put a very small air compresser inside a vac tank and run it? Put the pressure side to the outside of the tank.
WALAH....a vac pump.

You still gotta buy a vacuum switch though...more money and when I was hunting down parts initally for my brake system..I did not find any cheap ones.

This idea gives me another idea...what if you take the pump I mentioned above and just put it inside a vacuum reservoir with the exhaust side exiting the tank. I made mine like everybody usually does out of pvc tube and endcaps with brass barbed fittings. This would be a good way to make it virtually silent too....hmmm..I already wanted to make another bigger reservoir...I just might do this.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top