DIY Electric Car Forums banner
1 - 1 of 1 Posts

· Registered
72,624 Posts
Discussion Starter · #1 ·
In my ever searching quest to ride my Ev of useless
weight.Is it possible to make the field coil housing
which is cast iron now, out of billet aluminum?. Jim
yours ears on out their.
I searched the archives and didn't find any hits on
the idea.
I have both NC milling equipment at my disposal and a
large engine lathe that I would use?
Thanks, Jeff McCabe

For subscription options, see
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.