DIY Electric Car Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
70 Posts
Discussion Starter · #1 ·
I was thinking about what Roland was saying about adding something to
give some mechanical holding and the hawker brass post have a allen
screw in them ( this is what holds them the the hawker battery's )
which one could use , buy taping the melted terminal to that thread .
And I worked so hard to get that allen out of the brass post . I think
you would have to do a last turn with the allen wrench when the solder
melted but that wouldn't be hard with a long allen wrench .
Steve Clunn

--
Tomorrows Ride TODAY !
Visit our shop web page at: www.Greenshedconversions.com

_______________________________________________
| REPLYING: address your message to [email protected] only.
| Multiple-address or CCed messages may be rejected.
| UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub
| OTHER HELP: http://evdl.org/help/
| OPTIONS: http://lists.sjsu.edu/mailman/listinfo/ev
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top