DIY Electric Car Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1 (Edited)
For Sale: EV pack charger

Clicked on edit/delete to delete but can't find the delete option... so this sentence. Thanks for looking, all gone but charger. TC Charger, 230V 6K 144V $350 plus shipping from Western Oregon, USA.
 

Attachments

·
Registered
Joined
·
21 Posts
Discussion Starter #3
Thanks Duncan. I was actually trying to figure out how to delete the message from the edit/delete button... but failed to figure it out so I modified the message. Am I just not 'seeing' the delete option? ErvB
 

·
Registered
Joined
·
21 Posts
Discussion Starter #5
NikMish ~ I recall reading an article that stated they can... but you would have to verify that by doing some research. EVTV Motor Werks LLC offered a simple 'box' attachment that allows one to change parameters, stating; 'you CAN easily control to change the charge voltage, current, and termination at any time and without special software programs. And we've made it ridiculously simple'. I would review their article online for more info. ErvB
 

·
Registered
Joined
·
3,927 Posts
I believe you can only use the external device on those chargers that have CAN. Any earlier one like I have it must be done differently from the company. Not sure if the company in Sacrament still exists. If it does they can change it for you for a fee and cost of shipping to and fro. I had them give me a custom algorithm for my charger. :)
 

·
Registered
Joined
·
21 Posts
Discussion Starter #7
I attached a copy of the document that came with the charger. It shows using either CAN or Enable for control. I used the Enable feature for my application. Also added end plate info. I fed from a 230v source while anything from 100V to 240v AC is doable. I suppose that the company that I bought it from would know if its CAN programmable or not. If there is interest I will contact them.
 

Attachments

1 - 7 of 7 Posts
Top