Good work as usual, boekel. Is the splined output shaft the same diameter and number of teeth (splines) as the Gen2? A side by side comparison with a Gen2 motor would be great, if possible.
It looks virtually identical to the 2015 motor with the exception of the water inlet (or outlet) that is at 90 degrees instead of straight and the end cover opposite the motor shaft which has an extra bubble on the one side.
I -think- it is 19 splines (counted but didn't write down..)
outer diameter about 21,5mm, inner about 19,2mm
I wouldn't put a flywheel on this spline... I think I'd re-use (part of) the original gearbox with the bearing + axle if I'd have to mate something to the motor.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
DIY Electric Car Forums
A forum community dedicated to DIY electric car owners and enthusiasts. Come join the discussion about electric vehicle conversions, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!