DIY Electric Car Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
86 Posts
I am in the process of about the same point. I have only hooked up power and ground to the Orion, then also the CAN high and low (with resistor). I have confirmed that I can communicate and push a profile.

My questions to you are: Which model of orion are you using? What is wired up to the Orion currently (battery cells, current sensor, thermistors)? Are you using the orion CANdapter and cable? Can you connect to the orion, just not push a profile? Can you read the current profile from the Orion?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top