DIY Electric Car Forums banner

How to assemble the P&S Controller

2071 4
Hi everyone,
I was looking at the populated version of the Paul and Sabrina DC controller (https://pandspowerelectronics.ecwid...rol-Driver-Board/p/59121616/category=22093524)

On the information page, it discusses that there are a few extra things I need to get to make it work, specifically IGBT half bridges and a bus capacitor, but I can't find out what exact models I should be looking for in regards to these extra components. The build guides I have found are either the AC version of this, or they don't give a component list.

What exactly should I be looking for to get this controller up and running if I purchase this populated version.

1 - 5 of 5 Posts

· Registered
153 Posts
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.