DIY Electric Car Forums banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
In the OCPP specification there is "Unlock Connector".
How it works ?
I suppose that upon receiving the "Unlock Connector" command through OCPP, a charger should send a command to the connector through the CAN bus. If this is correct, where can I find information on how to create such a CAN message.
One more question - this feature be implemented on all types of connectors (i.e. Type 2, CHAdeMO, Combo2, etc.) or only on particular ones ?
Thanks in advance.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.