DIY Electric Car Forums banner

Hyper 9 can bus information: No RPM ?

1360 Views 2 Replies 2 Participants Last post by  poloLbricolo
Hi all,

I am finishing my conversion project with a Hyper 9 + BMS Orion 2 system and I use the Torque application to display all CAN bus information on my tablet.

Nevertheless I've no information coming from the controller, and especially a very important one which are RPM & Motor current !
I've been looking at the software but they are not part of the available list, do you know why and how can I get those ?

Cheers !
122830
1 - 3 of 3 Posts
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top