DIY Electric Car Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hi All,

I am in need of some assistance.

I have a warp drive classic controller, and it is throwing an error 18: "IGBT not responding to shutoff command."

The error is very intermittent. Sometimes it will throw sometimes not. Sometimes it will clear, sometimes not. It did not do it when I initially built the car, but does it now after very little use.

It is a 144v Thundersky battery setup. Reversing contactor setup with a warp 9 motor.

Any assistance would be much appreciated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top