DIY Electric Car Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have a problem on SEVCON Gen4. My problem is CAN node id cannot communicate with IXXAT v2. It's happen after I update the SEVCON Firmware using DVT version 2020.9a and SEVCON LED indicator always on without any blinking. I also attached my test:
 

Attachments

·
Registered
Joined
·
1 Posts
I have a problem on SEVCON Gen4. My problem is CAN node id cannot communicate with IXXAT v2. It's happen after I update the SEVCON Firmware using DVT version 2020.9a and SEVCON LED indicator always on without any blinking. I also attached my test:
Did you try power cycle and checked whether it is communicating at different CAN speed?
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Did you try power cycle and checked whether it is communicating at different CAN speed?
Thank you for your answer.
We have tried all of the different CAN speeds. But it's still not working for me. And I think the power cycle is OK. I have checked it. The SEVCON indicator is still stuck in green without blinking and I can't connect my IXXAT to SEVCON.
 
1 - 3 of 3 Posts
Top