DIY Electric Car Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #6 ·
Here is the manual for it https://kellycontroller.com/wp-content/uploads/kac-h/KellyKAC-HUserManualV1.10.pdf
It doesn't provide a pinout for that connector, but it does call out the fact it's an RS232 interface - RS232 uses 12v signalling (thus programmer would likely want 12v power supply too), so make sure you don't try to hook up a TTL level UART converter to it.
Yes you are right 12v is coming out from the 4p jst. anyway i have managed the original cables today.Thanks
 
1 - 6 of 6 Posts
Top