DIY Electric Car Forums banner

Kelly IPS controller with Andromeda IG Display

1470 3
So I trying to get my Andromeda Display to work with my Kelly 8080ips Controller to work Via CANbus to display the Signals based on the Kelly CAN bus protocol.



I have created a .dbc File to work, but one thing I am wondering is in the kelly configuration software when you click on the "COM" button there is only a single parameter to enter a value listed a J CAN Address. In the user manual there is nothing about this mentioned unless I overlooked it some how.



What is this parameter? Has any one use the kelly CANbus protocol to work with a CAN based display before?



Thanks!



1 - 2 of 2 Posts
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top