DIY Electric Car Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I've got a Ford/Siemens ranger motor, brand new with all the mechanical done to put in in my S10 and an RMS drive to go with it. I'm lacking the round grey plastic connector to mate to the tach/temp port on the motor, next to the three phase input gland nuts. It has 6 pins. The opening has a flat with lock tab on top. The opening is about 1/2" across and 3/4" from the flat to the bottom.

If you have any idea of a source for the mate, please reply.
 
1 - 1 of 1 Posts
Top