DIY Electric Car Forums banner

Machine shop recommendations for adapter/coupling job in NorCal

4369 Views 7 Replies 5 Participants Last post by  brainzel
Hi folks,
Can anyone recommend a machine shop in Northern California that can design and cut adapter plates and coupler for EV conversion?
1 - 8 of 8 Posts
Currently BMW 3series and Fiat Spider.
Locations around San Francisco Bay area will work
CanEV.com has a big repertoire of cars they have done... good solid design for retaining clutch mounting ICE flywheel/clutchplate on motor hub, and not TOO expensive.
3
Hi folks,
Can anyone recommend a machine shop in Northern California that can design and cut adapter plates and coupler for EV conversion?
I used G. B. Engineering for my adapter, Greg the owner is awesome, there isn't anything he can't do. He was located in Gilroy, I believe he has a new 6000 sqft shop in Milpitas. He doesn't have a website, but here is his contact info.
http://www.manta.com/c/mm89t4k/g-b-engineering


Here is how he built my adapter:







Everything was super accurate and dowel pinned. All the parts slipped together perfectly, and even at 10k rpm there are no vibrations. Highly recommend Greg's shop.
See less See more
Any contact info for CalEV.com?
Did you meen canev.com ?
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top