DIY Electric Car Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I am attempting to make a harness that will interface the sevcon gen4 controller with my computer Via IXXAT CAN cable. I have the cable and i have the connector kit but i need to wire it. the manual has not been very helpful in giving me specifics so could one of you guys help me out? I am using this controller with a ME1616 motor and also need to figure out how to connect it to the motor. any help is appreciated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top