DIY Electric Car Forums banner
Cancel

Netgain Interface Module flashes

1357 Views 1 Reply 1 Participant Last post by  F16bmathis, 
F
My Netgain WarP-Drive controller is always heating up to a point where it slows down even in winter after a 10 minutes slow ride. The Interface Module that displays all the settings and such, just flashes, nothing readable, so I can't see what the controller temp thinks it is at.

I've tried ordering a new one, but no-one has returned my request for purchase, so... does anyone know how to repair an LCD driver circuit?

I have tried using a different cable from the controller to the display and the same happens.

Thanks!
Reply
Save
Like
1 - 2 of 2 Posts
F
So... opened up the display for the third time in some months and found two hard wires from the main board going to the upper board had bad solder connections. Soldered them up and I have a display.

Now I have no communications! Tried another comm cable, but it didn't help. If it aint one thing...
Reply
Save
Like
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
DIY Electric Car Forums
A forum community dedicated to DIY electric car owners and enthusiasts. Come join the discussion about electric vehicle conversions, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
All EV Conversions and Builds Batteries and Charging Technical Discussion New Member Introductions eBay EV-Related Auctions
Top