DIY Electric Car Forums banner
1 - 1 of 1 Posts

· Registered
72 Posts
Discussion Starter · #1 ·
I have looked through the forums pretty closely and tried my best to find the answer.

I am looking for any info on the size of the complete leaf motor unit/inverter/pdm as seen in the Gen 2 leafs.

My basic plan is to convert a crx I have been restoring to electric and step 1 is figuring out if it will even fit. I know the modules can be separated and wired back together. I would much prefer to keep the unit in its oem config for simplicity.

My backup would be a gen1 unit but I am hoping to buy a crashed vehicle to harvest several components from and the larger batteries in the newer leafs is very enticing.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.