DIY Electric Car Forums banner
1 - 2 of 2 Posts

· Registered
27 Posts
Discussion Starter · #1 · (Edited)
As above really.

Used Orion 2 BMS with new looms:

CUSTOM KIT - 72 cell 12 ft voltage tap harness (I did this so
you will get two 36 cell harnesses, making it easier to split
the battery pack up if you decide to), main I/O harness (6ft),
Current sensor/thermistor harness (includes 8x 2 meter
thermistors), CANdapter (device used to program the BMS
using a PC) &Orion BMS 2 Current Sensor 1000A sensor

In the UK


Grille Motor vehicle Bumper Hood Automotive exterior
Font Technology Electronic device Rectangle Electric blue
Automotive lighting Automotive tire Automotive design Gas Automotive exterior
Automotive lighting Hood Automotive tire Automotive exterior Bumper
Light Orange Red Material property Font
Light Automotive tire Font Eyewear Eyelash
Light Red Font Electrical wiring Cable
Automotive tire Font Plastic Auto part Automotive wheel system
Automotive tire Black Grey Cable Auto part
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.