DIY Electric Car Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
314 Posts
I don't think I can help you, but I also have a GLMP20L2 motor which is going into a 1988 Honda Prelude conversion. And it would appear that they used the same lousy font and bad colour contrast on the drawings so you can't see the official hole spacing or PCD. It would be great to know if the diameter is 222 mm or something either side of it.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top