DIY Electric Car Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
8,126 Posts
Hey Major, I've been able to figure out a bunch of things to get this project going. But in calculating the drive sprocket ratios/sizing I'm not sure what rpm range I should be using for the calculation (for the motor in my first post).
Thoughts?

Thanks.
Up thread:
Hi,

Speeds of 2500 to 3500 RPM in the 7 to 8 HP range. Motor can tolerate higher voltage but do you need it? Staying at 48 V or below keeps associated component costs down.

major
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top