DIY Electric Car Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
70 Posts
Discussion Starter #1
Re: [EVDL] 9" adv Aluminum feild coil housing ?

In a message dated 10/24/2007 9:56:25 AM US Mountain Standard Time,
[email protected] writes:
> inum feild coil housing ?
> Date:10/24/2007 9:56:25 AM US Mountain Standard Time
> From:[email protected]
> Reply-to:[email protected]
> To:[email protected]
> Received from Internet:
>
>
>
> In my ever searching quest to ride my Ev of useless
> weight.Is it possible to make the field coil housing
> which is cast iron now, out of billet aluminum?. Jim
> yours ears on out their.
> I searched the archives and didn't find any hits on
> the idea.
> I have both NC milling equipment at my disposal and a
> large engine lathe that I would use?
> Thanks, Jeff McCabe
> http://www.austinev.org/evalbum/736
The field housing is part of the magnetic path. D Berube
_______________________________________________
For subscription options, see
http://lists.sjsu.edu/mailman/listinfo/ev
 
1 - 1 of 1 Posts
Top