DIY Electric Car Forums banner
1 - 1 of 1 Posts

70 Posts
Discussion Starter · #1 ·
Re: [EVDL] Phd in Materials Science on LiFePO4 batteries video WAS: Lithium 60ah 144v

"80% is where the knee is."
Not for my 180Ah CALB cells. The upper knee is at about 3.45V, and I can
get less than 5Ah into them from that point before they hit their high
voltage of 3.6V, so the knee is at greater than 97% charge - I datalogged
with a cell log8.

Nice datalogger!
View this message in context:
Sent from the Electric Vehicle Discussion List mailing list archive at

| REPLYING: address your message to [email protected] only.
| Multiple-address or CCed messages may be rejected.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.