DIY Electric Car Forums banner
1 - 3 of 3 Posts

1 Posts
Discussion Starter · #1 ·
I have an electric bus with an Curtis 1238 - 7501 controller. I would like to reduce the power of the motor when the batterie gets low. I want to use an Raspberry PI to record voltage data of the batterie cells. If possible I would like to connect the Curtis the PI and send signales from the PI to the curtis when the batterie is low.

Is this possible?
How can I connect to the Curtis?

Thank You

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.