DIY Electric Car Forums banner
1 - 1 of 1 Posts

40 Posts
Discussion Starter · #1 ·
As I slowly progress on my EV build, one thing I wanted to get round to figuring out is the gear selector. Using eBay I decided to pick up a Chrysler 200 rotary gear selector that I thought would go well in my conversion.

However, I now need to figure out the pins and where to find a suitable connector for it as it did not come with a harness / wiring. I’ve tried researching on the web but nothing particularly fruitful yet so next stop would be to contact a local Chrysler dealer. I then thought it a good idea to check in here on the forum in case anyone has had any experience with this type of gear selector.

The model I bought can be found here

Advice & input welcome!
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.