DIY Electric Car Forums banner
Cancel

Series wound with a Curtis 1231 -did I get it right?

1005 Views 4 Replies 3 Participants Last post by  remy_martian, 
4
Automotive tire Motor vehicle Vehicle Steering part Steering wheel
Motor vehicle Electrical wiring Gas Wire Auto part
Automotive tire Motor vehicle Vehicle Steering part Steering wheel

Motor vehicle Electrical wiring Gas Wire Auto part
Save Share
Reply Quote
1 - 3 of 3 Posts
4

· Registered
Joined
·
4 Posts
Discussion Starter · #2 ·
Don’t worry it is jus mock up. No voltage anywhere near. Cables are just to show r6es (on’t wan to. New ones until Inw the route). First picture has only clues on motor, right is A2 and left is A1
 
4

· Registered
Joined
·
4 Posts
Discussion Starter · #4 ·
Appologies. This is only a mock up and so there is no need to worry if this mock up is completely wrong. But please help me get it correct. The cables also are only intended to show the runs, new cables will be made when I can confirm this controller to motor wiring is correct. I believe I have followed the Curtis Manual, alas, it does not look correct on the motors.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
DIY Electric Car Forums
A forum community dedicated to DIY electric car owners and enthusiasts. Come join the discussion about electric vehicle conversions, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
All EV Conversions and Builds Batteries and Charging EVDL List Technical Discussion New Member Introductions
Top